The best way to Correctly Restore Your Water Damaged Drywall. Holes are simple to make in drywall, but happily they’re simple to fix. Outdoors corners on walls take quite a lot of abuse and might become dented and broken over time. Picture 3: Fill the holes with joint compound, swiping first across the holes, then down.

Joint tape is product of mesh and strengthens the bond between the patch and the wall, decreasing movement and serving to to forestall future cracks. Sand it smooth and apply a second coat if vital. This sometimes causes inside corners to crack or ripple. Sink the screws beneath the surface of the drywall.

Sand the compound easy, then apply another layer of joint compound, using a 6- or 8-in. Measure, minimize and install new drywall to suit the repair space (picture 2). You’ll want to use drywall that matches the original wall thickness. Set the drywall patch in place and screw it into the furring strips, sinking the screws beneath the surface of the drywall.

Fully clean your pan and knife before mixing a brand new batch. Sand almost to the drywall floor (you don’t need to go too far and minimize into the drywall paper), and vacuum away the mud. Have the mandatory instruments for this DIY challenge lined up earlier than you start—you will save time and frustration.

Photo three: Lay a 1/8-in.-thick mattress of drywall compound over the joints and press paper tape into the compound with a flexible 6-in. Fastidiously sand the dried compound, utilizing a drywall sanding block or more and more finer grits or sandpaper. Using a broad-bladed putty knife, spread joint compound over the groove so that it fills the realm and covers an inch or two on either side.